Multitek Comm-Box Spécifications télécharger pdf (Page 29)

3.0 PROGRAMMING MODBUS REGISTERS SEQUENCE

If changing of the modbus order is not required please move

to section 4.0 communication.

3.1 Using the M550 Software.

M550 software can be obtained from your Multitek

distributor or from our website www.multitek-ltd.com.

3.2 Load disc and open Mbregs, (This is the Modbus Regis-

ters Tool program) and the screen below will be displayed.

4.3 This software allows the user to alter the sequence in

which the Modbus addresses are read. So for example if the

user was only interested in Watts Hz Power Factor, then

these 3 registers could be set as the first 3 and the

remaining registers ignored.

The following parameters are set by default to the

following readings, all can be changed if required. See

section 2.3 to 2.6. Response time = 300mS, Node = 1,

M550MAN.PM5 01/08/101, 12:4827

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 54 55

Pas de commentaire

Multitek Comm-Box Spécifications Page 29